Power Train

Page 25

Previous | Table of Contents | Next

Volvo Bus Service and Maintenance Manual

 Closing contact/inductive sender, splitter or disengage signal EGS-system
44 Check/adjust if necessary.
 
 Tamperproof seals
45 Check that the tamperproof seal for the speedometer or tachograph has not been tampered with.
 

Inductive sender, splitter or EGS-signal

(B10M from chassis number 20001)

Check the distance between the inductive sender and the clutch pedal indicating plate with the clutch pedal fully depressed. The distance should be 3±0.5 mm.

Clutch pedal inductive sender

Tamperproof seals

The tamperproof seals on the sensor for the speedometer/tachograph and the kilometre monitor must be of approved type.

Speedometer/tachograph sensor
Speedometer/tachograph sensor
Speedometer/tachograph sensor/a>
Kilometre monitor